1 gal. of honey by volume=12lbs. of honey by weight [192oz.]
1 qt. of honey by volume=3lbs. of honey by weight [48oz.]
1 pt. of honey by volume=1.5lbs. of honey by weight [24oz.]
1 cup of honey by volume= .75lbs. of of honey by weight [12oz.]

 

Those are estimated weights by volume
A regular quart canning filled to the ring around the top below the lid is not a true 3lbs.

 

I have found my honey is pretty consistently 44 oz for a quart and 22 oz for a pint.

 

Thank You All,

 

Depends on moisture content. It will vary. Especially noticable in large volume containers like 55 gallon drums.

 

What is the general rule for estimating weight of honey for a quart or gallon?

1 gal. of honey by volume=12lbs. of honey by weight [192oz.]
1 qt. of honey by volume=3lbs. of honey by weight [48oz.]
1 pt. of honey by volume=1.5lbs. of honey by weight [24oz.]
1 cup of honey by volume= .75lbs. of of honey by weight [12oz.]

Take note, this is only a 'general rule for estimating' weight of honey for a quart or gallon by volume. I seriously doubt that anyone actually weighs 1 cup honeybear to put the actual weight. A 1 cup honeybear by volume would be labeled as 12oz. of honey, regardless of whether it weighs 11, 12, or 13 oz. If this is different, I would appreciate to know the implications of varying actual weight of honey.

 

I just extracted between 15 and 20 gals. of honey today. I bottled a couple [2] 8oz. honeybears and 1- 12oz. honeybear [by filling to the brim]. I weighed the bottles with the lids empty and then my full bottles. Each honey bear contained over 8oz and over 12 oz. of honey after deducting the weight of the containers. I used a scale designed to weigh precious metals so it is very accurate.

I then repeated the test with the 12 oz. honey bear [which is supposed to be 1 cup by volume]. Once I removed enough honey back down to where the indented lid area started, the honey weighed exactly 12oz. [after deducting the honeybear weight], or so close there was no noticable difference. I then filled a honey bear with water above the indented area, and poured the water into a 1 cup measuring. The 12 oz. honeybear filled above the indented area ran over a 1 cup measuring cup. I then refilled the 12oz. honey bear with water just to where the indented area began and again poured into a 1 cup measuring cup. It ran over by just the smallest bit.

So, I would say based upon the above experiment [with my honey extracted today], that an 8oz. or 12oz. honeybear filed to the indented lid area, but not beyond, contains 8oz. or 12oz. of honey respectively. When the containers are filled above the indented cap area to the top of the container, they weigh slightly over 8oz. or 12oz. of honey respectively.

Kindest Regards
Danny Unger

 

gallon 12 lbs

 

That depends on where it is! If you take it north of the border it will weigh a bit over 14 lbs. Nominally it is close to 1.42 times heavier than the same volume of water.

Depends on how accurate you want to be and what the moisture content is. That can vary from 16 to a bit over 18%. Stuff on shelves that has been pasteurized can run up to something over 19% water and wont ferment. Raw honey at anything near that high will ferment.