Joined
·
11,921 Posts
Location:
State of Disrepair
Welcome to Beesource!
> How do I change the measurements to make follower boards that will fit Bushs' hive dimensions ...
Make the hive per Mr Bush's plans, but use screws to attach one of the end boards instead of nails. Then run a pencil mark around the inside corners of the end board (where the sides meet the end). Now remove the screws from the end board and cut it based on the pencil marks. Attach a new board for the TBH end.
> How do I change the measurements to make follower boards that will fit Bushs' hive dimensions ...
Make the hive per Mr Bush's plans, but use screws to attach one of the end boards instead of nails. Then run a pencil mark around the inside corners of the end board (where the sides meet the end). Now remove the screws from the end board and cut it based on the pencil marks. Attach a new board for the TBH end.
