Beesource Beekeeping Forums banner
1 - 1 of 5 Posts

· Registered
Joined
·
290 Posts
I use a compound miter to cut the boards to length (or have Lowe's do it slightly proud if I'm lazy), then my table saw to rip to exactly width. I don't have a dado, so I make two cuts for the frame rests. When I get my new shop set up, I'll switch over that task to my router table & rabbet bit.
 
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top