Beesource Beekeeping Forums banner

1 - 10 of 10 Posts

·
Registered
Joined
·
1,683 Posts
You do not want the bit attached to the drill. I like using bamboo scewers. The work great for odd jobs. They will go in the hole of the candle mold. You do not want to damage your mold so be careful of the sides.

I have poured hot water from the kettle into my poly mold, but the water is 150F (make sure to take the temp) Depending on how big the piece is that might work. But if it is big....could take a while.
 

·
Registered
Joined
·
2,239 Posts
a long "deck" screw, needle nose pliers to pull. works fine good luck,mike
 
1 - 10 of 10 Posts
Top