Can I make beehives from 1x4 lumber with the same structural integrity as the normal 1x12 or close? The reason for this is to save money. At my local Menards a 6ft 1x12 cost $15.36 while 6ft 1x4 cost 1.99, this means I could purchase the necessary lumber for 1 deep box for $6. I was thinking I could stagger the joints on the sides and ends so everything is well attached. Has anyone ever done this before?
David6272
Joined
·
1,930 Posts
I use Advantech subfloor sheets to make my hive bodies. I have been using Advantech for 9 years now and the boxes are still in fantastic condition. The edges have held up better than pine holds up. I prime and then paint the boxes. Using Advantech will add about three pounds to the weight of a box.
I can make 4-1/2 deeps plus a medium out of a sheet, Or four deeps and two mediums, or 8 mediums. At 2025 prices its about $9/box for deeps and $7/box for mediums.
I can make 4-1/2 deeps plus a medium out of a sheet, Or four deeps and two mediums, or 8 mediums. At 2025 prices its about $9/box for deeps and $7/box for mediums.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
