Beesource Beekeeping Forums banner
1 - 1 of 1 Posts

1,072 Posts
Discussion Starter · #1 ·
I am planning on running my hives similar to the set up like in the point of view by Jerry Hayes.

I plan on a couple of variances:
A standard bottom board, entrance reducer and a parallel slatted rack on the bottom of the brood boxes.

I am looking at queen excluders and do not see one that is "seven wire" I am inclined to use the welded and crimped unit but it looks as though it has six wires.
Of the available queen excluders, which one would work best for this application?
Could the wood bound one be modified by cutting a notch across the front instead of installing the spacer material which would be 3/8 or 1/2"?

Any comments would be appreciated.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.