Well I really messed up today. I bought a sheet of plywood 3/4 inch 4x8 sheet. I wanted to make the D Coates nucs. Well if you have a sharp eye you already know what I did wrong. After I cut all the pieces and assemble 1 nuc box I realized what I did. The frame did not fit inside that's how I found out. The plans are for 1/2 inch plywood. My nuc box was small by quarter inch. I had to tear it apart and rebuild with the joints sticking out 1/8 inch all sides. Then had to make up the top piece that covers the frame edge. So I built 2 because I have 2 queens coming today or tomorrow. Hell it don't look that bad but a lot less sturdy than full joints. I want to make more but how would I resize the plans for 3/4 inch plywood so I can make new nucs for future use?