I have tryed many times to make the box joints for my deep boxes I cant do it I made this jig I saw online I dont know what I am doing wrong all joints I make are exactly the same can I git some help here im lost:s
The spacing and dado width must be exactly the same on both pieces. Stagger the pair of short ends one tooth off the pair of long ends. I will try to get a picture ASAP. It is simplest to use 3/4 inch until you get the hang of box joints.
Not to complicate things but you can cut 5/8 if you step or increment at 5/8 also. 3/4 works out evenly on deeps and mediums with a little more meat in each finger. I would rather go 7/8 than 5/8 for strength.
Maybe I am reading this wrong, but when making box joints you need to take the first piece of wood and reverse it when you cut your second piece. If you don't do that the joints only match they don't intertwine like you want.
It makes a difference in how you flip the pieces end to end too. You can't just flip the board over and cut the opposite end. Mark one edge as the top, and the top faces the same direction for cutting either end.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Beesource Beekeeping Forums
1.8M posts
54.7K members
Since 1999
A forum community dedicated to beekeeping, bee owners and enthusiasts. Come join the discussion about breeding, honey production, health, behavior, hives, housing, adopting, care, classifieds, and more!