Re: Placing queen cells
Moon: sounds like you have most of the basics right. I like to try to get a balance of sealed and open brood in each nuc and allow them to sit queenless for 1 to 2 days before installing your cell. I don't use cell protectors but they are cheap and may prevent an occassional problem and are probably a good precaution. If installing a 10 day cells put them on the side of a frame of brood being careful not to "roll" it as you slide the frame back, don't fall prey to the temptation to hang them between 2 top bars especially if nightime temps are expected to be low, they can easily get chilled, we only do that if the cells are a "hot" 11 day cell and temps are mild. I only like to use cells that are 10 or 11 days old. They can take a little rough handling and aren't nearly as likely to get destroyed by the hive. I recently used some 7 day old cells out of necessity and later found on checkbacks that around half of them were in the process of raising a new virgin. In this case I am confident that handling wasn't the problem as they were taken directly from the builder to the nuc on a warm afternoon and handled as delicately as I could.
"People will generally accept facts as truth only if the facts agree with what they already believe."- Andy Rooney