Hello all,
I have a little, maybe big, problem in one of my hives here. I just replaced the screened bottom board with a solid bottom board, and in the process I noticed a hole chewed in the (plastic) screen and mouse droppings on the floor. Hmm, I thought, because I had an entrance reducer, but obviously that didn't keep the mouse out. There were no nesting materials on the floor of the hive, so I figured it just came for a visit. Well, I came back to this;
Picture 098.jpg
Obviously not just a visit, and I'm sure the mouse is setting up residence there. I would close of the hole, but I don't want to shut it in there. What should I do? Put poison outside the hive? Suggestions? Thanks in advance.



Reply With Quote
If you succeed a notch on your hive tool would be appropriate.
I had to chuckle (loudly) when reading these suggestions. I have killed 6 mice before with my hive tool, good idea of putting notches per victory in it.














Bookmarks