Re: dado fingers question
I have never used the Incra Jig. So I don not know exactly how the adjustment stuff works. I simply make a finger joint jig out of a couple of scraps of wood when I need them.
In the photo. notice he has the edge of the piece set against the index pin of the jig. when the second notch is cut he will move the piece so that the first notch fits on the index pen. etc. The last notch will be the partial one.
If you wanted the first notch to be at the edge of the board you would put a spacer the width of a finger next to the index pin and then put the edge of the piece against that.
Last edited by Daniel Y; 12-21-2012 at 07:50 PM.
Significant Minority vs Insignificant Majority, 20% of causes produce 80% of the effects.