Sorry at work, don't have any pictures at the momment, but I made a schematic real quick on paint. The end bar blank (usually a 2x4 or 2x6 with a dado groove in the end for me) slides in from the side. The endbar is only held in the front and back which is all you need. You can hold the 2x4 and slide the end bar forward without getting anywhere near the cutter. I reccomend screwing the pieces on from the top so your screw heads don't show on the bottom as well, and I clamp a block to the jointer as a stop so I don't cut too far. You have to make a different holder for each size of endbar also.
Endbar Holder for Jointer Schematic.jpg
Hopefully the schematic attaches ok, let me know if that doesn't work I'll try to dig it out of the shop later tonight to take a pic if needed.
Make sure to UN-click the box for the McAfee Security software unless you really want it as well.
USDA Zone 7A Elevation 1400 ft
This may help: http://www.beesource.com/forums/show...Photo-Tutorial
Benjamin Schneider - http://prairiewindbeesupply.webs.com/