pin cell cups

[olky]

does anyone else have trouble with pin cell cups falling out of grooved cell bar? is there a trick to putting them in? thanks

[Joseph Clemens]

Mine were falling out too, now I fill the grooves with beeswax, none have fallen out since.

[Velbert]

Yelp if new and there falling out the groove was to wide to began with. But even if they don't fall out the first few times they get looser with usage


What i like is to drill the holes get a bit that is a tad smaller than the tit on the cup it will be tight at first but works a lot better. Mark your center then drill a hole just a little over 3/4 inch apart this way you can get about 19 cups per bar