Perma Comb Uncapping Tool

[Ronnie Elliott]

I was reading on the forum about a wheel type tool with spikes used for piercing capped honey in the perma comb. I think Wild Bill was talking about where to order one, if not does anyone know where to buy such a contraption?

[Flyer Jim]

I think this is what you are looking for

http://www.plastools.com/honey_punch.

[Romahawk]

Hackler Honey Punch

http://www.plastools.com/index.html

[BULLSEYE BILL]

He, he, your funny,,, Wild Bill....

Ok, so when you order your hackler honey punch, order the two inch. When you get it remove one wheel so the spikes will separate and fall into the cells easier.

The two inch model causes less strain on your wrist than the four inch, when using the four inch you will end up using the outside edge because the wheels will not all fall into the frame because of spacing and because of the ridge in the center line of the frame.

The only two tools I use are a plastic pie server to remove the cappings and the punch when the cappings are at or below the cell openings. No hot water is necessary to heat the punch, the PC will make the wheels turn making it unnecessary to warm the punch.

[Ronnie Elliott]

Bill I new you had said one size you liked better than the others. I thought I had saved that info, but what can you expect from a old geezer who just turned the big 60. thanks fellas for the info.

[BULLSEYE BILL]

what can you expect from a old geezer who just turned the big 60. .

I'm right behind ya bud.