Deck Paint vs. Oil to latex ect ect?
I bought new honey supers and I'm interested in hearing of the different paint options out here for exterior finishes. Ask any painters and they say oil first then latex.
Any one out their have 2 cents? What approach or efficient methods or products are you using? Any ideas would be great to read!!
PS is't almost river season
Ask any painters and they say oil first then latex.
You might want to try this method on some scrap wood and see the results.
Please take a close look at the ZINZER products.
They are like appying cream to the wood and their primer is top of the line.
Ex paint and decorator uses acrylic primer then 2 top coats
For me, I used a top line acrylic primer (cheaper in 4 Lt tins over here instead of single Lts) when it was still all in bits.
I chose paint that had been incorrectly tinted at the Trade counter of the paint shop.
I didn't paint the inside surfaces cause I am relatively new to this hobby & I understand it is not the thing to do. I did all the joints and edges where water might/may creep into then after making up the boxes/supers, I then took an inch brush with Primer on it and dabbed Primer on the nails 'cause when they went into the timber during construction, they cracked the wood (untreated Pinus Radiata) ever so slightly. So...after construction, I then gave them 2 coats of acrylic high gloss.
I chose acylic as it has a building effect so as the cracks where the joints are on the corners, get filled up with paint to help keep the water out.
I would agree that the oil based paints will last longer but they dont have that building effect to protect the joints from suckin in water. That wouldn't have been a problem if both inside and outside surfaces (and joint edges) were painted.
If I wasn't in so much of a hurry to get my hives up and full-a-b's then I would have painted the whole sha-bang with oil. Oil based Primer then oil based undercoat then a top coat of full gloss.
One thing I would do now though, is have a hardwwod for a landing strip for the wee critters. If the surface is painted, water sits on top of it and if they aren't too exact in their flying /landing ability, they often end upside down on their backs and get stuck on the wet surface. If it was unpainted and rough sawn, then they wouldn't have a problem. The next hives will have raw hardwood timber doorstep with no paint on it.
Its interesting seeing what other folks do isn't it.
Good luck Cheers