Hutch
05-11-2006, 07:49 PM
Does anyone have any experience with the 9/18 radial extractor from Mann Lake. It looks to be a good deal but I am concerned about it being made from 26 guage stainless steel. Is this to light?
tecumseh
05-12-2006, 06:19 AM
hutch ask:
Is this to light?
tecumseh replies:
well I guess it would depend on what you were going to use the extractor for...... likely the gauge indicated seems quite appropriate for sending a bit of stainless thru a roller press (which is what you use to make round object from flat plates) without encountering a lot of difficulties or expense..
Michael Bush
05-12-2006, 06:40 AM
>Does anyone have any experience with the 9/18 radial extractor from Mann Lake. It looks to be a good deal but I am concerned about it being made from 26 guage stainless steel. Is this to light?
I have one. I like it a lot. No, it's not too light. When I'm moving it, I wouldn't mind if it was lighter. smile.gif